Virtual (shared) IP
One of the biggest pain points when building a high-availability controlplane is giving clients a single IP or URL at which they can reach any of the controlplane nodes. The most common approaches all require external resources: reverse proxy, load balancer, BGP, and DNS.
Using a “Virtual” IP address, on the other hand, provides high availability without external coordination or resources, so long as the controlplane members share a layer 2 network. In practical terms, this means that they are all connected via a switch, with no router in between them.
The term “virtual” is misleading here. The IP address is real, and it is assigned to an interface. Instead, what actually happens is that the controlplane machines vie for control of the shared IP address using etcd elections. There can be only one owner of the IP address at any given time, but if that owner disappears or becomes non-responsive, another owner will be chosen, and it will take up the mantle: the IP address.
Talos has (as of version 0.9) built-in support for this form of shared IP address,
and it can utilize this for both the Kubernetes API server and the Talos endpoint set.
etcd for elections and leadership (control) of the IP address.
It is not reccomended to use a virtual IP to access the API of Talos itself, since the
node using the shared IP is not deterministic and could change.
To see a live demo of this writeup, see the video below:
Choose your Shared IP
To begin with, you should choose your shared IP address. It should generally be a reserved, unused IP address in the same subnet as your controlplane nodes. It should not be assigned or assignable by your DHCP server.
For our example, we will assume that the controlplane nodes have the following IP addresses:
We then choose our shared IP to be:
Configure your Talos Machines
The shared IP setting is only valid for controlplane nodes.
For the example above, each of the controlplane nodes should have the following Machine Config snippet:
machine: network: interfaces: - interface: eth0 dhcp: true vip: ip: 192.168.0.15
Virtual IP’s can also be configured on a VLAN interface.
machine: network: interfaces: - interface: eth0 dhcp: true vip: ip: 192.168.0.15 vlans: - vlanId: 100 dhcp: true vip: ip: 192.168.1.15
Obviously, for your own environment, the interface and the DHCP setting may
You are free to use static addressing (
cidr) instead of DHCP.
In general, the shared IP should just work.
However, since it relies on
etcd for elections, the shared IP will not come
alive until after you have bootstrapped Kubernetes.
In general, this is not a problem, but it does mean that you cannot use the
shared IP when issuing the
talosctl bootstrap command.
Instead, that command will need to target one of the controlplane nodes